Breeding Tank for Satellite S

Thank you for viewing.

This product is a Breeding Tank for Satellite S. The Satellite S comes with a V-shaped slope originally intended for breeding. Have you ever isolated a fish that seemed close to giving birth, only for it to not give birth for a while? In such cases, the sludge that accumulates at the bottom of the Satellite can be a problem. If you use the original V-shaped slope, it becomes a rather troublesome process: remove the fish -> remove the slope -> clean -> replace the slope -> return the fish. That's where the Breeding Tank for Satellite S comes in. By setting this in the Satellite S and placing the fish inside, if the birth is delayed and sludge accumulates, you can remove the entire tank with the fish inside, temporarily place it in a small container with aquarium water, and then return it after cleaning. Those who have experienced the inconvenience of cleaning multiple times will surely understand. Also, when fry are born, you can remove the parent fish with the tank and use the Satellite as is for the fry. Removing parent fish from the Satellite with a net can be difficult and surprisingly stressful, can't it?

The product is made of a plastic called PETG and is a DIY product made with a home 3D printer. It is an assembly type and can be disassembled as shown in the photos, making it space-saving for storage.

Shipping will be via RakuRaku Mercari便 Nekoposu. Shipping is free.

This product is a DIY creation using a home 3D printer. Therefore, layer marks, small scratches, chips, etc., may occur. We ask that only those who understand and can accept these imperfections purchase the product.