Haitani Style Jump Button Lever Harness Header Pin Type

New, unused
Cable length: 38.5cm (excluding white parts and pins)

This is a modified header pin type lever harness that allows connection to buttons.

It enables you to create the lever that became a hot topic when Mr. Haitani tweeted about it. Mr. Eita also uses high-speed commands with a jump button. Recently, Mr. Mago and Mr. Fuudo have also ordered jump buttons. This is a custom modification that may become mainstream in the pro scene.

Connect to the jump button as shown in the photo.
*Assumes GND is already wired to the button.
*For Raspberry Pi GP2040 boards.

You can disable the up direction on the lever and assign the jump function to a button.

★General Benefits

When transitioning from crouching guard to standing guard while observing an overhead attack, you can perform a standing guard by pressing the jump button without changing the lever position.

By inputting the vacuum hado command up to the diagonal and pressing the jump button, you can achieve a direct horizontal input, speeding up the command (Mr. Mago claims it comes out in 9 frames).

It also speeds up Shoryuken inputs (testified by Mr. Eita and Mr. Mago).

★Chun-Li Specific Benefits

[Hold Down Input → Press and Release Jump Button → K Button]

This allows for high-speed Tensho-kyaku.

[Down Input] ↓
[Simultaneous Input of Jump Button Press and Down Input] N
[Releasing the Jump Button results in only Down Input] ↓

This is the mechanism.

In addition to the advantage of being able to input N↓N↓ like a leverless controller,
it also prevents accidental lever inputs and unintended jumps.

#RealArcade #HORI #RAP #HAYABUSA #Hayabusa
#ArcadeController #Lever #Custom #Cable #Harness
#RaspberryPi #Brook